Audi Q2 GA 1.4 TFSI, 150 PS, 6-speed manual (2016–2018)

Research for this car

• Generation guide Audi Q2 (since 2016): known problems and buying guide

  A solid used buy; check the brake pedal recall, the parking brake and the brake discs before you pay.

• Engine guide VW 1.2 and 1.4 TSI (EA211) petrol engines: problems, costs and what to check

  Oil use and water pump leaks are the reported faults. Buy with a belt and pump record and a clean oil check.

Known issues for this car

Before you buy this car

From the generation guide

1. Measure the rear brake discs and look at the pads. Bad result: worn-down discs or pads. A rear disc change costs 251-487 EUR (Germany, year not stated). Rear changes need a scanner to open the electric parking brake.
2. Look at the side blade on the C-pillar (the pillar behind the rear door). Bad result: a blade that is loose or partly off. Ask for recall 53D2 status.
3. Ask a dealer to confirm that recall 72H9 (headrest weld) is done. Bad result: an open campaign.
4. Ask a dealer to check the VIN (the car's chassis number) for any open recall campaign. Bad result: any open campaign.

From the engine guide

1. Oil level (no scanner needed). Check the dipstick and ask for the oil-use history. Bad: the level falls between services, or blue smoke comes out under hard acceleration. Ask for proof of any ring or head work.
2. Coolant and water pump (no scanner needed). Check the coolant level when the engine is cold, and look under the car for wet stains near the pump. Bad: a low level or any leak. Ask for a dated invoice showing the pump was changed with the belt.
3. Invoices. Ask for dated invoices with the mileage for any belt, pump, oil or software work. No record means budget for the job.
4. Recall check. Enter the VIN in the official recall check for the car's country. Bad: an open campaign on the car.

Running costs

ADAC figures for 15,000 km a year over 60 months

ADAC versions