BMW 4er-Reihe F32/F33/F36/F82/F83 430d Coupé, 258 PS, 8-speed automatic, rear-wheel drive (2013–2017)

Research for this car

• Generation guide BMW 4 Series F32/F33/F36 (2013-2021): known problems and buying guide

  A usable buy with recall work on record. Avoid early N20 petrol cars with no chain work on record.

• Engine guide BMW N57 3.0 diesel (330d, 530d, X5 30d): problems, costs and what to check

  A six-cylinder diesel with costly chain risk, so buy only with recall proof and oil and chain records.

• Gearbox guide ZF 8HP 8-speed automatic (BMW Steptronic): problems, costs and what to check

  A solid 8-speed when its fluid is changed on time. Buy with oil records and a clean scan, and avoid one that shudders or has run in limp mode.

Known issues for this car

Before you buy this car

From the generation guide

1. Lift the car and check the springs, shock absorbers and tie rod ends. Bad result: leaking shocks, worn tie rod ends, or knocks over bumps.
2. Ask for proof that the EGR cooler recall was done on a six-cylinder diesel built 2013 to 2015. Bad result: no proof.

From the engine guide

1. Chain (cold-start test, invoice). Listen for a rattle on a cold start. Ask for a chain job invoice. Bad: a rattle, or no chain record past 100,000 km.
2. Damper (look under the pulley). Check the rubber ring of the crankshaft pulley for cracks or a loose ring. Ask for a damper replacement receipt. Bad: visible cracks, or no record on a car over 100,000 km.
3. EGR recall (check the VIN). Check the VIN with a BMW dealer or the KBA recall list (reference 008124). Bad: an open campaign, or a cooler replaced with no record.
4. Swirl flaps and intake (ask for records). Ask whether the intake was cleaned and the flaps checked. Bad: no record at about 100,000 km, or a flap removed with no proof.
5. EGR and flap faults (scanner needed). Read the fault memory for EGR or swirl flap errors. Bad: any such error, or the engine warning light.
6. Oil history (paperwork). Check the service book for regular oil changes. Bad: long gaps between oil changes.

From the gearbox guide

1. Read the gearbox fault memory with a BMW-capable scanner. Bad result: pressure or solenoid codes such as 4F84, 4F87, P189C or P0748, or a past limp mode.
2. Ask for fluid and filter invoices. Bad result: no fluid change by 80,000 to 120,000 km, or a change without an adaptation reset.
3. Drive the car from cold and select Drive and Reverse. Bad result: a hard 1-2 shift, or a delay of 1-3 seconds before the gear engages.
4. Drive 15 minutes in town, then under load. Bad result: jerky 2-3 shifts, flaring, slipping or a burnt smell.
5. Hold a steady light throttle at low speed. Bad result: a shudder or vibration, which points to the torque converter lock-up clutch.
6. Look under the car on a lift. Bad result: oil at the wiring connector on the case, on the plastic pan or on the cooler lines.

Running costs

ADAC figures for 15,000 km a year over 60 months

ADAC versions