SEAT Ateca 5FP facelift 1.0 TSI, 116 PS, 6-speed manual (2020–2026)

Research for this car

• Generation guide Seat Ateca (since 2016): known problems and buying guide

  A strong used SUV if it is dry, rust-free and has had its recalls done; check the tailgate and infotainment.

• Engine guide VW 1.0 TSI three-cylinder petrol (EA211): problems, costs and what to check

  A strong small engine, but check the coolant module, the injector recall and the turbo wastegate before you buy.

Known issues for this car

Before you buy this car

From the generation guide

1. Press the carpets, boot floor and spare-wheel well, and look at the headlining near the mirror. Bad result: damp, stains or a musty smell.
2. Look under the rear light clusters, along the rear door seals and the sills. Bad result: paint lifting, an orange tinge or bubbles.
3. Open and close the powered tailgate several times and listen to the struts. Bad result: a slow or dead tailgate. A scan of module 6D shows stored codes.
4. Read the last inspection report and look at the brake discs. Bad result: a deep lip, a poor contact pattern or brakes flagged.
5. Switch on the ignition and check that all four front parking sensors report. A scanner shows park-pilot faults; inspect the loom at the bumper bend.
6. Test the radio, navigation, Apple CarPlay and Android Auto for a few minutes. Bad result: restarts, a blank screen or dropped phones.
7. Ask a dealer for all open campaigns by VIN, including steering campaign 48T7. Bad result: an open campaign.

From the engine guide

1. Camshaft adjuster bolts (listen, 2018-2020 cars). Listen for grinding or scraping at the timing belt cover on a cold start. Ask whether the bolt check (TPI 2038019) was done. Bad: a grinding noise or no record on a 2018-2020 car.
2. Timing belt, water pump and oil (no scanner). Ask for dated invoices with mileage for belt, pump and oil changes. Check the coolant cold. Bad: no record, low coolant, white crystals at the pump.
3. Turbo wastegate (scanner). Warm engine, roll in third, add light throttle; listen for a metallic rattle. Read P2563 and P0299, including deleted entries. Bad: rattle or limp mode.
4. Injectors and recall (scanner). Check the VIN for 24FO, 24FP or 24FQ. Scan fuel trims and misfires. Bad: an open recall, fuel smell or misfire.
5. Intake, coils and plugs (scanner). Scan P0300-P0304 and check for rough idle, misfire under load, or a flashing engine light. Ask for a plug invoice at 60,000 km. Bad: a misfire that moves with a swapped coil.

Running costs

ADAC figures for 15,000 km a year over 60 months

ADAC versions