Skoda Octavia 3. Generation facelift 1.0 TSI, 115 PS, 6-speed manual (2017–2020)

Research for this car

• Generation guide Skoda Octavia III (2013-2020): known problems and buying guide

  A practical family car, but test the gearbox and check the 4x4 oil record, the suspension and any open recall before you buy.

• Engine guide VW 1.0 TSI three-cylinder petrol (EA211): problems, costs and what to check

  A strong small engine, but check the coolant module, the injector recall and the turbo wastegate before you buy.

Known issues for this car

Before you buy this car

From the generation guide

1. Test-drive the DSG from cold, then read the gearbox fault memory with a scanner. Bad result: any stored gearbox fault.
2. Lift the car. Check the springs for cracks and breaks, the shocks for oil, and the arm bushes for play. Springs are changed in pairs. Bad result: a broken or cracked spring, or leaking shocks.
3. Switch on every light and check each LED lamp. Bad result: a dead or flickering lamp. A controller repair has no confirmed price.
4. Pull back the carpets at the front footwells and check the door drains. Bad result: damp carpet or rust under it.
5. Check the tailgate edge around the number plate lamp and the paint on the bonnet and doors. Bad result: bubbling paint or rust at the tailgate.
6. Test the screen, navigation and Bluetooth pairing. Ask for the software version. Bad result: freezes or restarts. Skoda updates the software free.
7. Open and close the fuel flap several times, including on a cold morning. Bad result: the flap does not open.
8. Check open campaigns by VIN with a Skoda dealer before you pay. Bad result: an open campaign on the car.

From the engine guide

1. Camshaft adjuster bolts (listen, 2018-2020 cars). Listen for grinding or scraping at the timing belt cover on a cold start. Ask whether the bolt check (TPI 2038019) was done. Bad: a grinding noise or no record on a 2018-2020 car.
2. Timing belt, water pump and oil (no scanner). Ask for dated invoices with mileage for belt, pump and oil changes. Check the coolant cold. Bad: no record, low coolant, white crystals at the pump.
3. Turbo wastegate (scanner). Warm engine, roll in third, add light throttle; listen for a metallic rattle. Read P2563 and P0299, including deleted entries. Bad: rattle or limp mode.
4. Injectors and recall (scanner). Check the VIN for 24FO, 24FP or 24FQ. Scan fuel trims and misfires. Bad: an open recall, fuel smell or misfire.
5. Intake, coils and plugs (scanner). Scan P0300-P0304 and check for rough idle, misfire under load, or a flashing engine light. Ask for a plug invoice at 60,000 km. Bad: a misfire that moves with a swapped coil.

Running costs

ADAC figures for 15,000 km a year over 60 months

ADAC versions