Skoda Fabia 3. Generation facelift 1.0 TSI, 95 PS, 7-speed dual-clutch (2020–2022)

Research for this car

• Generation guide Skoda Fabia III (2014-2021): known problems and buying guide

  Breakdown and inspection records are good. Check the recalls, the brakes and the DSG gearbox before you buy.

• Engine guide VW 1.0 TSI three-cylinder petrol (EA211): problems, costs and what to check

  A strong small engine, but check the coolant module, the injector recall and the turbo wastegate before you buy.

Known issues for this car

Before you buy this car

From the generation guide

1. Recall check by VIN. Ask a Skoda dealer to check open recalls by VIN. Ask for proof of any driver airbag or injector work. Bad result: an open campaign, or no proof for a car built 2014 to 2018 or a 1.0 TSI built 2018 to 2019.
2. Foot brake and handbrake. Press the brake pedal hard at a stop. Pull the handbrake on a slope. Bad result: a pedal that feels weak or uneven, or a handbrake that sticks or does not hold.
3. Brake discs. Look through the wheel at the disc edge. Bad result: deep grooves, or discs that look worn down to the edge.
4. Exhaust. Look under the car at the silencer and the pipes. Bad result: holes, cracks or a loose box.
5. Low beam. Switch on the low beam in front of a wall, from a fixed spot. Bad result: a light cut-off that sits too high or too low, or is uneven from side to side.
6. Phone pairing. Pair your phone with the touchscreen during the test drive. Bad result: pairing fails or keeps dropping.

From the engine guide

1. Camshaft adjuster bolts (listen, 2018-2020 cars). Listen for grinding or scraping at the timing belt cover on a cold start. Ask whether the bolt check (TPI 2038019) was done. Bad: a grinding noise or no record on a 2018-2020 car.
2. Timing belt, water pump and oil (no scanner). Ask for dated invoices with mileage for belt, pump and oil changes. Check the coolant cold. Bad: no record, low coolant, white crystals at the pump.
3. Turbo wastegate (scanner). Warm engine, roll in third, add light throttle; listen for a metallic rattle. Read P2563 and P0299, including deleted entries. Bad: rattle or limp mode.
4. Injectors and recall (scanner). Check the VIN for 24FO, 24FP or 24FQ. Scan fuel trims and misfires. Bad: an open recall, fuel smell or misfire.
5. Intake, coils and plugs (scanner). Scan P0300-P0304 and check for rough idle, misfire under load, or a flashing engine light. Ask for a plug invoice at 60,000 km. Bad: a misfire that moves with a swapped coil.

Running costs

ADAC figures for 15,000 km a year over 60 months

ADAC versions